Matlab and SimuLink Development Forum

Hi,


I would like to know whether matlab support interfacing with a FPGA board. I am not talking about Simulink only matlab. I would like to apply noise cancellation technique on a FPGA board using matlab but I don't know whether this is even possible. If so than how do I do so. I am new to FPGA but I would really like to experiment with it.


Any suggestion.

thanks for the positive reply,

I have been searching for a book that could teach me the basic of FPGA but so far I have no luck. Could you suggest me any book that would make it earlier for me to learn the basic function of FPGA.

thanks

I am using Altera cyclone 2...

Actually I am working on a university project in which I have to apply adaptive noise cancellation technique on to a FPGA using Digital Signal Processing....

I am very interested in learning Verilog or VHDL too....but so far I haven't found any good website or book that could teach me verilog/ VHDL properly....